A properly installed electrical system plays a key roll in
the AC Electromagnetic Field (EMF) Pollution levels in a
building. Proper grounding can significantly reduce Electric
Fields. Neutral wire isolation can reduce unwanted Magnetic
Fields thus eliminating Net Currents. It is important to
reduce long term, low level exposure to Electric and
Magnetic Fields. Obtaining accurate exposure readings is
also very important. Please visit our EMF Meter, RF Meter
and Body Voltage Meter pages for Bau-Biologie approved
testing equipment. See below for our suggestions on how to
lower your EMF exposure at home:
Sleep in a room that has been electromagnetically evaluated.
Bau-Biologie Exposure Standards for sleeping areas indicate
that Magnetic and Electric Fields should be as low as
possible, preferably under 0.2 mG (milliGauss) or 200 nT (nanoTesla)
for Magnetic Fields and below 1 V/m (Volt per Meter) for
Electric Fields. Ideal Body Voltage readings should be below
10 mV (milliVolts). Seek the professional advice of a
trained Bau-Biologist.
Shut off the electricity in your bedroom during sleeping
hours. This can be accomplished manually by turning off the
breakers or automatically with a Demand Switch. This will
eliminate electric field exposure while sleeping.
Avoid placing a bed on a shared wall with a neighbouring
apartment if in a townhouse or apartment building. Your
neighbours may have electronic equipment or electrical
appliances on the other side of the wall.
Remove all dimmer switches used in the house. They emit high
magnetic fields and cause dirty electricity.
Verify that all circuits in the house are properly grounded.
Use 3 wire shielded cable (BX) for wiring a home. The
metallic jacket shields Electric Fields.
Plug 3-wire appliances into working 3-wire outlets.
Locate the power panel at least 15 feet from living /
sleeping areas.
Locate hot water heater (electric) at least 10 feet from
living/sleeping areas.
Locate clothes dryer 14 feet from living/sleeping areas.
Most new Ground Fault Interrupter (GFI)'s generate constant
Magnetic Fields and dirty electricity.
Install a non-metallic junction (Dielectric Union) where the
metal water pipe enters the ground. (Just after the water
meter) This will help prevent stray ground current from
entering your home and infest the water pipes.
Sterling Heights, Michigan
Modesto, California
Macedonia, Skjope
Iran, Teheran
Albuquerque, New Mexico
New Haven, Connecticut
Belarus, Minsk
Shepparton, Victoria
Pakistan, Islamabad
Daftah, United Arab Emirates, Daftah, UAE
Try any
Q-Link or
cell chip
for 3 months, absolutely
RISK-FREE If you do not feel Q-Link improves your
focus, energy, or well-being, simply return it for a full
refund.
Airtube headsets have
30 a day refund.